I just love the vintage charm that it adds to the Christmas decor.
So I headed to Home Depot and picked up a simple 5’x5′ drop cloth to start.
The steps were pretty simple, and I’d recommend just popping on some good Christmas tunes to keep you company.
Let’s get started…
1. Layout your drop cloth and iron out the wrinkles. I put my iron on the lowest setting and made sure to put a towel underneath so as not to sear anything to my lovely hardwood floors. MY husband would not have been too happy about that. 🙂
2. I used our previous tree skirt, as seen under the tree yesterday, as a pattern. If you don’t have a tree skirt to measure, you can simply use your math skills and measure out a circle to be your desired diameter.
3. Cut out said drop cloth following traced pattern. Easy enough.
Step 4 & 5:
4. Use a ruler, I determined the halfway point on the skirt, which happened to be at 11″, and knew that would be the center of the thickest stripe. I marked 11″ all the way around the skirt because I’m terrible at eye-balling, and have always been a “color in the lines” type, girl. This stripe was 2 inches wide all the way around.
5. For the smaller ticking stripe, I simply measured about an inch below the thicker stripe and marked that all the way around the skirt.
I originally had marked off two thinner stripes, like the photo, but painting the stripes in took longer than I anticipated, so I bailed. An additional thinner stripe probably would look a little better if I’m honest.
6. I simply grabbed a small sponge brush and painted it in my stripes all the way around. The red that I used was Behr’s Regal Red. It happens to be the perfect Christmas red for my home this year, and I’m using it all over the place!
It adds the perfect amount of vintage charm to the tree!
Not too shabby for $5.99!